USB gamepad.cfg input_device = "USB gamepad " input_driver = "udev" input_r_btn = "5" input_save_state_btn = "5" input_start_btn = "9" input_exit_emulator_btn = "9" input_l_btn = "4" input_load_state_btn = "4" input_up_axis = "-1" input_a_btn = "1" input_b_btn = "2" input_reset_btn = "2" input_down_axis = "+1" input_right_axis = "+0" input_state_slot_increase_axis = "+0" input_x_btn = "0" input_menu_toggle_btn = "0" input_select_btn = "8" input_enable_hotkey_btn = "8" input_y_btn = "3" input_left_axis = "-0" input_state_slot_decrease_axis = "-0"Īs seen above in the config for the USB SNES controller, each input on the controller has an associated value. Each emulator page on the wiki has a diagram of the original controller for its respective console that will correspond to the same inputs listed below.Īfter you've configured your controller the autoconfig will be created here: They can be used as a reference when configuring your controllers. The following diagrams are for the 3 most common controllers: Super Nintendo, Xbox 360, and PlayStation 3. You'll know if your controller has been automagically configured if you see a flash of yellow text on the bottom of the screen with your gamepad ID when you start a game. Your joypad is automagically configured for libretro (RetroArch) emulators when you configure your controller in EmulationStation. You can also access it from the start menu within EmulationStation under the Configure Input option. RetroArch controls have been integrated into EmulationStation and will be the first thing you see when you boot from the RetroPie SD image the first time.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |